Shimano BB-UN55 68x113 Square Taper Bottom Bracket. My old bottom bracket was a 68x113, but when I changed out my crank set I ended up needing a 68x122 to accommodate it. I realized this after purchasing this bottom bracket. It turns out to get the proper chain line spacing you need to choose the crankset and BB as a pair, or rather choose the crankset you want, get it in and measure the chain rings to the start of the square taper to figure out the offset needed, and then choose the BB to get that offset. This bottom bracket comes in the box. The box is heavily worn, but the bottom bracket is in good/ like new condition. One interesting thing I noticed about this BB-UN55 bottom bracket is that the non-drive-side cup does not fit snugly on the BB. It appears to have a step that engages the chamfer on that side of the bottom bracket. Because I never installed this on my bike I'm not quite sure how it works. I looked this up and others have seen this setup and it sounds like the NDS cup will likely not fully thread in to the frame (intentionally). https://www.bikeforums.net/bicycle-mechanics/1150388-un55-square-taper-bottom-bracket-non-drive-side-metal-cup-hits-up-against-something.html